Hi All,

Have wanted to do a T-45 Power Armour ever since Funko released this figure so here it is.

Figure - The figure is the Funko T-45 Power Armour and I pulled it apart and he assembled it and changed the tanks at the back and turned them around added new hoses which are between the head and shoulders and changed the hoses from the bottom of the tank to the sides of the armour.

I replaced the hands and gave it new ones from the Bandai Darth Vader figure and then added armour plates on top of the hands on the feet and around the biceps and triceps. I also added a small switch on the right side pipe the connects to the helmet, I added small parts to the sides of the feet to simulate motivators. The gattling gun was built using plasti card and a small tube and also hoses and wire, I used small nuts from a 1/20 model kit.

Base - is built up using high density foam and the billboard was made using plumbers pipe and plasti card and the poster I got of the net and printed it off and attached it the billboard and then sanded it and then gave it different washes to give it a worn look to it.

The ground work is a mixer of plaster, sand, small rocks and dirt mixed together and then spread over the base, it was then painted and weathered to simulate a scorched earth look. The small shrubs are from Army painter and the little dead plant roots are real roots I got from the garden a dried them out and the small trunk was from the garden as well.

Ron