Used a Marvel Universe 3.75" Hulk to craft this cyborg up! This was actually from an ebay fodder lot I acquired recently and my son already had this hulk which was complete and not missing any pieces but I brainstormed and decided to make the Eternals Robot Hulk! This fodder hulk was missing his entire left hand - I sculpted the one you see from scratch the peg is a screw the rest is hand sculpted with paint applied.

I sanded down:
- Chest.
- Back.
- Around the sides.
- Left arm.

I wanted to sand the areas down so the apoxie sculpt would seems slightly lower than skin or similar height as I didn't want it to be "above" the skin as it's supposed to be below respectively! The entire silver chest side, back and arms have sculpt applied. I did mix up some green paint using shades of green with a little black and white to match it better. Painted his left eye red and then finally applied "Dark Lord Black" wash I purchased from StarWarsGeek Customs to really make the arm "pop".

Swapped out his right hand with a MU Planet Hulk so one hand could carry a tool/weapon.

I'd say pretty good, it's not an exact match to the comic drawings but considering it's 3.75" scale I'd say not too shabby for my first truly in-depth sculpt job and I was short on time at that! This bad boy had to be finished before Christmas with limited time and it was right around 4am the paint was drying I could swear I saw Santa leaving when I went to put him under the tree!!! If I had more time this could have been amazing but for the time spent I'm very proud of myself and my son loves him so that made it all worth it!

Included a picture of the original figure side-by-side. Let me know what you think and thanks for looking :D.