Figures used: Movie Masters Bane and the Movie Masters two-pack shirtless Bane.

I began by removing the coat with an x-acto knife and then began splicing the upper body seams with a small box cutter very carfefully not to damage the exterior of the figure or breaking it. Once the seams were accessible I took a eyeglasses screwdriver and wedged into the seams carefully and slowly looseing the glue and finally separating it allowing me to remove arms of the figure and set it aside. Next I moved onto the shirtless Bane which was the easier figure to break down since I was planning to discarding the upper-body piece anyhow, I used the same process as before but was obviously more aggressive in separating the piece and taking the arms of the figure out and discarding the rest of the figure. I moved back to the standard Bane, taking the back portion and leg section and set the sleeveless arms in place, applying a light amount of glue in the inside peg holes of the upper-body piece and lightly around the seams before applying the top piece firmly and holding it tightly until it sealed.

Side note: I choose to also exchange the heads of the two figures as well, this was based purely on my opinion that the shirtless Bane had a better painted head-sculpt and didn't set at a downward angle like the other head.