This idea was floating around in my head for sometime, so I took a 12" robert englund figure and used milliput around the face. The eyes, nose and mouth I kept.The hardest part was getting the pattern design on the head. The neck piece at the back, I used cardboard and folded it a little--the piece just under the neck was off the inside of an old computer harddrive. The chest plate I made out of a piece of leather and used a metallic button. The ball parts on the shoulder was made from using a glue gun then I put the wire mesh around it and left them hanging below the elbow.I stood the figure in a half a plastic bottle and secured it to the figure using a glue gun and I put the material around that and built the different layers of material using pinks and purples. The pattern on the pink material was done using the glue gun and painting the glue purple. I made a base for it which is hard to see in the picture but the base was cut out of soft wood board and again I used the glue gun to make ooze shapes on the base then painted them purple.