Hi All,

Ghostbusters Peter Venkman 1:12 scale.

Recipe.

Venkman - is from Hasbro's Plasma Series and once I got him in a pose I liked I then super glued the joints and puttied them up, I then used tissue paper and applied it to the uniform using watered down PVA glue. I repainted the utility belt, ghost trap, proton pack and neutrino wand using Vallejo Paints and I also added wires which I got from an old electrical cable and danger signs I resized and printed off the net.

I made the foot trap using plastic card, clear rod and wires and the cord from the foot trap to the ghost trap is an old ear phone cord. The smoke coming from the ghost trap is just some cotton wool which I tore apart and glued on and once the tissue was dry I then painted and slightly weathered the whole figure using Vallejo Paints.

Base - is high density foam and I used a sharp pencil to make the footpath, stone work and bricks and then I used a piece of sandstone and lightly tapped it over the brick, path and stone to give it a more natural look. The cement between the bricks was done by brushing spakfilla over them and then lightly wiping away the excess with a baby wipe. The door was done using balsa wood and the handle is plastic card and rod, the slime was done by mixing green paint with PVA glue and I little Woodland Scenics Realistic Water.