I used craft foam for the boot tops and shoulder cuffs. Sculpted the mask and hair. Used claws from a Toybiz Wolverine. I'm working on a Litterbug to round out this group....[See More]

Ground down the boots for a better look and re-worked the collar. I think the sash/belt was from Sleepwalker. Sword is from Pirate Deadpool. I hand painted the bird....[See More]

Yes, going with a Red Guardian would have been a better choice however it was a bit cost prohibitive. Pretty much just a repaint....[See More]

My thanks to torkmaker 64 for the inspiration for these. Picked up a couple Terror Dogs online. Removed the feet and sculpted in the hooves. I used more sculpt for tuffs of fur, the horns, and the...[See More]

I wanted to try a concept piece. I guess I see this as a Medival human Optimus Prime (I did a name search for hope or optimism and picked Titus. It was not until after I made the decision that I...[See More]

For the Marvel Legends scale, The It is a little short but for the Universe scale it works pretty well. Ground away a lot of details and lots of Green Stuff to fill holes and smooth out some details...[See More]

Not sure if there would be many more characters a Chamber base would be good for but I saw The Shadow when I looked at his eyes. Trimmed away his flames and sculpted the face covering and some more...[See More]

The is my take on Green Hornet and Kato. I had the WS/BZ from a lot win and liked the What If Starlord body. I decided to keep the headband on Shang-chi for something different....[See More]

Use a rubber band for the crown and then sculpted the hair and then covering the tunic to eliminate the designs....[See More]

This was a commissioned piece, kinda fun to try. Full head sculpt, more for the shoulder coverings, the belt is a rubber band and sculpt. Craft foam for the collar. I made the dagger thing out of a...[See More]

Peeled off Hydra's hair and sculpted on new. Just a little more sculpt for the cuffs and collar. The wings came from a fodder lot I picked up....[See More]

And the last of my Legion of Superheroes run, Energy Boy. Peeled off Sentry's hair and used rubber bands for some of the details. Used a gem for the chest piece....[See More]

A few fodder bits for the details. Sculpt for the hair, the bracers, and thigh boots. Energy Boy is almost done....[See More]

A relatively easy custom. Swapped heads, cut out the vest portion of the overcoat to open it up. Sculpted a new collar and made a new vest line under the jacket....[See More]

Zero issues with joint rub on this one. Craft foam for the collar and chest emblem. I swapped out the feet for some fodder ones. Just a little sculpt for the lower leg details and glove cuffs....[See More]

This is my third Yukon Jack, second time using Brother Voodoo. I wonder across all comic books, how many variations of Tarzan-like characters there are....[See More]

Re-sculpted the masked head from Capt. Marvel. The hair is from Hellcat and the fin is craft foam. Green Stuff for the chest piece and the boots and gloves. Rubber bands make the belt and arm bands...[See More]

Derath is a commissioned piece. Definitely falls into the category of characters not on my radar. I attempted initially to re-sculpt the arms to be more tentacle-like but it didn't quite have the...[See More]

The first figure of my last run of Legion of Superheroes members. Sculpted the neckline and sleeves and glove cuffs....[See More]

The last in my run of TV characters, the stache from Hawaii, Magnum PI. Side note, why are the originals still so much better than the reboots? I gave Rude's mullet a trim and sculpted the clothes....[See More]

A commissioned request, working on a few Acolytes. Removed a few details on the Ranger, resculpted the waist and gloves and used craft foam for the shoulder pads....[See More]

Went with this version of a custom request. Used the Siryn body for joint rub and the Binary head for well...duh, right! Used some fodder pieces for the belt and shoulder harness and rubber bands....[See More]

This was a commissioned piece. Sculpt for the hair, X, scale/spikes, jacket sleeves and cuffs, and boot tops. SO, when I was thinking I had him done, my customer asked about the Dragon Staff....[See More]

Fun, just fun. Ground around the details on the chair and sculpted over most of it. Sculpted the face and added a little more for the mouth. Build up the height with dowels. For those who are maybe...[See More]

My take on an old favorite show. My cape options were limited so went with a cloth one. Planning to finished this run with the greatest mustached detective...in Hawaii....[See More]

Last Legion member for this run is Impulse. Added the wrist and ankle cuffs and the ear wings and repainted. The Amazing Spider-man Iceman worked great for the body for this one....[See More]

This is my second Charlie-27. This one is a little closer to the correct size but still a little big. Sculpt for the boot cuffs and used googly eyes for the studs again. Used a different shade of...[See More]

I considered trying to add a face but I liked the look of the head the more I worked on it and thought why not consider it an updated look for him. Or at the very least (and more likely) my version...[See More]

Next up for this round of Legion of Superhero members is Kinetix. Pretty much just a straight repaint, with an added belt and a sculpted collar. AND Hallelujah!!! A use for the tulle I purchased for...[See More]

I had made a Fox Bard a while ago and after finding out there was a Squirrel Thief in the same group (all animal based) I wanted to try making him. I used a Fortnite Wildcard head to sculpt the head...[See More]