It was pretty sculpted, wanted to leave the joint torso but would see well sculpted. maybe for next to do....[See More]

just a little sculpting and painting....[See More]

basically it is a repaint of a figure gi joe, the only thing was sculpted head qie was just another gi joe finally did the harness combining two I had....[See More]

the body is of a colossus, hands and lower legs are ultron, thor layer and the head is cable. very sculpted. I hope you like....[See More]

quite simple, use upper body namor and half a wolverine in xmwo and sculpted head slightly namor with epoxy hair. I finally made the trident. I hope you like....[See More]

Only roughing hyperion boots and sculpted the rest with epoxy to finally paint it. I hope you like....[See More]

the body was of a wolverine in xmwo, legs like a sabertooth xmwo and head of a count dooku with some sculpted....[See More]

I used it as a base body of a wasp and head of elektra some recess and sculpted with epoxy. to finally paint. I hope you like....[See More]

nothing complicated, just a repaint a black suit spiderman....[See More]

elektra body with some sculpted head and for costume use teflon tape....[See More]

body iron man and lots of epoxy for sculpting....[See More]

multiple body man. falcon head, a little more sculpted. remove her leg and arm, add a cane and some sculpted for bands....[See More]

body nighthawk head of a wrestler wwe can not remember which, a little more sculpted belt of a strange Doctor layer of a darth vader sculpted the cane, shrunken head, skulls and eye Agamotto. I hope...[See More]

obviously use a punisher which will change the arms by a nick fury of avengers also use your boots and raincoat. finally paint the skull and belt and so will gradually leaving the thunderbolts....[See More]

pretty simple just use two more pairs of arms of titanium man, a head of ultron and some wire....[See More]

for this custom elektra use as a base to which he sculpted the mask and hood the rest is a somewhat laborious paint job, but I like the end result....[See More]

elektra used as a base to which he sculpted feet, fangs belt and medallion. hair use Starfire dc. finally I put a tail made of wire to finally paint....[See More]

pretty easy, you just change the hair by a ms. marvel over a scarf and repainted....[See More]

use based on a classic iron man armor, which required more sculpted legs quite a iron man extremis and sculpted head of a vision....[See More]

using the recipe from a fellow Customizer use a baraka-pool + the head of a Zartan of gi joe and a little sanding and painting....[See More]

simple enough after removing the wings, gloves and boots to a single captain america sculpted eyes. the rest is paint and good accessories, hope you like....[See More]

To make this custom, use a zemo base to which you add a galleon Dr. Strange, the layer of a cloack, the head with his helmet and medallion were sculpted with epoxy....[See More]

I quite liked this figure are the only bad leg so I decided to put joint. Cut the legs at the joint of the knee some recess a few holes. He was perhaps best then put another foot joint....[See More]

Use as a base Falcon which would cut recess wings and put the bracelets in addition to the hands of a sabertooth with tentacles made cable, the head is carnage line figures of Spider-Man...[See More]

this custom to use as a base Blastaar far sculpted epoxy and the head of a pre-legends toy biz Terrax....[See More]

To make this custom Zartan used as a base to which he sculpted the head and some details, plus put a new belt and hood. The shield can not remember that figure was only I put some magnets to easy...[See More]

use a hyperion, which will roughing the torso and some boots, the head is a doc. samsom with hair sculpted thor and some loincloth is a elektra....[See More]

was basically a repaint only changes your hair by a spider woman and gave him the crown and cape....[See More]

zemo body, the rest was sculpted and the head is called a ghost rider....[See More]

basis using a rhino, to which he sculpted with epoxy head and claws of the feet are the wings of an old figure toybiz and the loincloth is fabric. I hope you like it....[See More]